My Tarot T810 Drone build

The perfect place to show off your done building projects amongst other enthusiasts.
User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Tue May 31, 2016 11:29 pm

The extra tier on drone..

Ok I ordered another mainplate (Come with upper and bottom plate) for the T810. I only needed the lower plate as was adding another level below the bottom plate. The upper plate came in handy though, as I was able to cut it into two rectangular plates for mounting the landing gear motors as you will see in images.

I installed on to the bottom of this extra main plate Tarot Hexa-copter Power Distribution Board Signal Hub - TL6X002 to keep the job tidy and neat. On top of this hub you will see I added the Tarot TL8X002 Auto Landing Gear Controller to connect the 2x landing gear motors too. You will see I did a bit of customisation to the power hub, so I could connect the power lines from the ESC's using bullet connectors. Good if you need to remove bottom plate again.
You will also see in photo's a 8 in 1 Throttle Calibration Hub, which I'll show a pic of later. I think this being the best way to calibrate ESC's.

20151013_210421.jpg
20151013_210429.jpg
20151013_210452.jpg
20151013_210511.jpg
20151013_212040.jpg
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D

User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Tue May 31, 2016 11:34 pm

Continued.....

20151013_212112.jpg
20151013_213306.jpg
20151013_213319.jpg
20151013_213326.jpg
20151013_213345.jpg
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D

User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Tue May 31, 2016 11:53 pm

Calibrating ESC's

Before attempting to connect my ESC's to the flight controller I want to calibrate them so they know my full throttle range. I like calibrating all at the same time. I do this rather than doing them individually so I know all ESC's are calibrated the exactly the same. As explained before I use the 8 in 1 Throttle Calibration Hub from hobbyking.

76534.jpg


I've attached two Youtube video on calibrating ESC's.

https://www.youtube.com/watch?v=UUaAH3SS2Vo
https://www.youtube.com/watch?v=OOplk52R4no
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D

User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Wed Jun 01, 2016 12:00 am

Ok So lets add the rest of the gubbings...


20151013_213834.jpg
20151013_233937.jpg
20151017_220710.jpg
20151017_220840.jpg
20160409_140902.jpg
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D

User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Wed Jun 01, 2016 12:13 am

Results after adding the Gimbal rails, battery floor, gimbal and Gopro 4

20160409_140917.jpg
20160409_140935.jpg
20160409_141145.jpg
20160409_141159.jpg
20160409_141448.jpg
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D

User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Wed Jun 01, 2016 12:16 am

Here are the rest of the Foxtech superb video's

FoxtechFPV Tarot T810 combo, Part 7

https://www.youtube.com/watch?v=1PqYNGAZhtM
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D

User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Wed Jun 01, 2016 12:17 am

FoxtechFPV Tarot T810 combo, Part 8

https://www.youtube.com/watch?v=fZaZhgMFD14
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D

User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Wed Jun 01, 2016 12:18 am

FoxtechFPV Tarot T810 combo, Part 9

https://www.youtube.com/watch?v=S1Cw_gUkCx0
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D

User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Wed Jun 01, 2016 12:20 am

Thanks for looking guys...

I will upload my nail biting maiden flight soon, as said earlier had never flew a drone of any size let alone built one. We will see how it goes. :shock:
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D

User avatar
PhilSnow
Registered User 5+ Posts
Registered User 5+ Posts
Donator
Donator
Posts: 25
Joined: Wed May 25, 2016 6:02 pm

Re: My Tarot T810 Drone build

Postby PhilSnow » Fri Jun 17, 2016 10:29 pm

Hi Guys here is the long awaited Maiden test flight of my T810 drone. Happy to say that there was no drama's.

https://www.youtube.com/watch?v=eU43-Adx6W4
:D Tarot T810 - DJI Naza M V2 - DJI Datalink - DJI OSD - DJI Zenmuse H4-3D - FrSky D8R-II PLUS - ImmersionRC TX :D


Return to “Drones”

Who is online

Users browsing this forum: No registered users and 1 guest

Created by EXODUS from ProjectDrone.xyz


Powered by phpBB® Forum Software © phpBB Limited
 

 

cron